8rdavcore is able to set voltages (VCore, Vdd, Vdimm, Vagp) and the FSB on different mainboards.

Setting the FSB, the Tras, Trcd, Trp memory-timings and the fan speed is also possible.

Tips:

- Run prime95 or something similar where you can see if a overclocked or undervoltaged processor produces errors.
- Use small steps to find a limit (VCore 0.05V, FSB 4Mhz)
- For my 8RDA+ this works: minimal FSB = (FSB at boot-time)-60, maximum FSB = (FSB at boot-time)+10
- 'Sensor' shows the measured voltages from the Winbond/ITE hardware monitor
- The CPU temp is from the socket (on 8RDA), not the internal diode
- Differences between theoretical and sensor values (+/- 0.05V) are normal

Currently supported mainboards: Abit NF7, Acorp NFU400N, Aopen AK79D-400VN, Asus A7N8X-EP, Chaintech CT-7NJ(S,L1), DFI Infinity NFII Ultra, DFI Lanparty NFII Ultra, Epox 8RDA+ Rev. 1.x, Epox 8RDA+ Rev. 2.x, Epox 8RDA(3,6,+,I,E), Gigabyte GA-7NNXP, Jetway N2PA, Leadtek K7NCR-18D, MSI K7N2 Delta, Shuttle AN35N Ultra V1.1, Shuttle SN45G, Soltek 75FRN(2)-L, Soltek NV400-L64.

What's New in This Release:

В· Added log option
В· Changed sensor main display
В· Added chart
В· Added Soltek NV400-L64
В· Changed preset editor
В· Fixed issue creating two AutoFSB entries with same name
В· Added shutdown control
В· Use multiplier calculation when > 12.5
В· Added Winbond W83627THF sensor
В· Added detection of I/O addresses for nVidia SMBUS
В· Added Gigabyte GA-7NNXP
В· Added Gigabyte GA-7N400 Pro
В· Added temperatures to system tray
В· Added Asus A7N8X v2.0 Deluxe